Brake pedal axle mount
1 - brake pedal; 2 - axle nut; 3 – an axis of a pedal of a brake; 4 - bracket
Brake pedal with bushings
1 - brake pedal; 2 - plastic sleeve; 3 - axle bush
1. Disconnect the wire from the terminal «-» battery.
2. Remove the glove box from the driver's side.
3. Unscrew the mounting bolt and remove the air duct for blowing the driver's legs (see subsection 11.6). On models equipped with «Comfort», remove the central control unit.
4. Remove the brake light switch (see subsection 9.10.7).
5. Disconnect the connector from the accelerator pedal position sensor.
6. Disconnect the brake pedal from the pusher of the vacuum booster (see subsection 9.1).
7. Loosen nut 2 (see fig. Brake pedal axle mount) fastening of an axis of a pedal of a brake.
8. Remove axle 3 and then brake pedal 1 from bracket 4.
9. Remove sleeve 3 (see fig. Brake pedal with bushings) axles from pedal 1.
10. Remove two plastic bushings 2 from pedal 1.
11. Insert two new bushings 2 into the brake pedal 1 up to the stop without distortion.
12. Insert the 3rd axle bush after lubricating its cavity with grease.
13. Install brake pedal 1 in reverse order. At the same time, latch the pedal 3 (see fig. Connecting the brake pedal to the pusher of the vacuum booster) brakes on the ball tip of the pusher 1 of the vacuum booster.
The tightening torque of the brake pedal axle nut is 28 Nm.