Attention! Editing the trunnion thread is prohibited. A stud with a damaged thread must be replaced.
1. On vehicles with ABS, disconnect the wire from the terminal «-» battery, disconnect the block with wires from the sensor 24 (see fig. Rear suspension parts with drum brakes) wheel speed, unscrew the fastening bolt 26 and remove the sensor 24.
2. Remove wheel hub (see subsection 7.3.1).
3. Turn away a fastening nut and disconnect a brake tube 20 from the wheel cylinder. Seal the opening of the tube, for example with an air bleed valve cap.
4. Turn away four bolts 7 fastenings and remove a brake board with a pin.
5. Remove pin 19 from the brake shield.
6. Install the pin in reverse order. At the same time, replace the bolts of the pin with the brake shield with new ones.
7. Bleed the brake system.
Tightening torques, Nm
| Nut of fastening of a brake tube | 14 |
| Bolts of fastening of a pin with a brake shield | 30, then turn 90° |
| Wheel bolts | 120 |