Attention! Editing the trunnion thread is prohibited. A stud with a damaged thread must be replaced.
1. On vehicles with ABS, disconnect the wire from the terminal «-» battery, disconnect the block with wires from the sensor 20 (see fig. Rear suspension parts with disc brakes) wheel speed, unscrew the fastening bolt 21 and remove the sensor 20.
2. Remove wheel hub (see subsection 7.3.2).
3. Unscrew the four fastening bolts 8 and remove the brake shield 9 with pin 15.
4. Remove pin 15 from brake shield 9.
5. Install the trunnion in the reverse order, replacing with new bolts 8 fastening the trunnion with the brake shield.
Tightening torques, Nm
| Bolts of fastening of a pin with a brake shield | 30, then turn 90° |
| Wheel bolts | 120 |