Attention! Attach the tow rope only to the special eyelets. Turn on the light signaling according to the Rules of the road.
Attention! If your vehicle is being towed with the engine off, insert the key into the switch (lock) ignition and turn on the ignition to turn off the anti-theft device (in no case turn off the ignition, otherwise the steering column may be blocked).
Attention! When the engine is not running, you will have to brake with great effort, since the vacuum booster is not working. If the engine is in good condition, start it up so that the brake booster operates, the battery does not discharge, and you can use the heater in cold weather.
Watch for signals from the towing vehicle. Try to constantly keep the cable taut when braking the car. If you are towing another vehicle with your vehicle, ensure that the tow rope is gradually tensioned when starting off (visually using the rear-view mirror and by increasing the load on the engine) and only then gradually increase the speed of movement. Avoid sudden acceleration, braking and turning. Keep to the right lane and do not change lanes unless necessary. Turn on your turn signals earlier than usual. Do not exceed the towing speed specified in the Rules of the Road.
Front towing eye
The front towing eye is removable and stored in the tool box.
1. Using a screwdriver, pry out the two latches (their locations are indicated by arrows) right ventilation grille 1 (starting with the fixator nearest to the center) and remove the grill from the front buffer 2.
2. Screw eyelet 1 into axle 3. Insert, for example, a mounting spatula into the hole in the eyelet and tighten the eyelet (2 - front buffer).
3. After towing the vehicle to the destination, remove the lug 1, place it in the tool box and install the ventilation grille, fixing it securely in the front buffer.
Rear towing eye
The rear towing eye 1 is located under the rear buffer 2 on the left side.