Front suspension parts
1 - telescopic stand; 2 - wheel drive assembly; 3 - locking plate; 4 – a bolt of fastening of the case of an internal SHRUS; 5 - wheel drive with internal CV joint «tripod»; 6 - locking plate («tripod»); 7 – a bolt of fastening of a drive («tripod»); 8 - brake disc; 9 – a bolt of fastening of a wheel; 10 - hub nut; 11 – the screw of fastening of a brake disk; 12 - brake shoe; 13 - support; 14 - guide pin; 15 - protective cap; 16 – a bolt of fastening of a board of a brake; 17 - hub; 18 - brake shield; 19 – a nut of a spherical finger of a tip of steering draft; 20 – a tip of steering draft; 21 - steering knuckle; 22 – a nut of a coupling bolt; 23 - coupling bolt; 24 - wheel speed sensor; 25 – a bolt of fastening of the gauge; 26 – a nut of fastening of a rack of the stabilizer; 27 - anti-roll bar
Pressing the splined tip of the outer CV joint from the hub
1 - puller; 2 - wheel hub
1. Loosen bolts 9 (see fig. Front suspension parts) fastening of the corresponding wheel and nut 10 of the wheel hub.
2. Raise and secure the front of the vehicle.
3. Remove the wheel and wheel arch locker.
4. Finally unscrew the nut 10 of the hub.
5. Unscrew six bolts 4 fastening the body of the inner CV joint to the axle shaft flange and remove the three locking plates 3. Hang the axle shaft on the wire to the body for insurance.
6. Turn the steering wheel all the way in the direction in which the outer tie rod end on the side of the removed drive will be directed outward from the vehicle axle, and take the shaft away from the axle shaft flange.
Attention! On models with power steering, do not keep the steering wheel turned to the end position for more than 15 seconds.
7. Using a special puller 1, press the splined tip of the outer CV joint out of the wheel hub 2 (see fig. Pressing the splined tip of the outer CV joint from the hub). In the absence of a puller, this can be done by hammer blows through a wooden spacer on the end of the splined tip.
8. Install the wheel drive in reverse order. At the same time, replace the bolts.
Tightening torques, Nm
| wheel hub nut | 30 |
| Bolts for fastening the body of the inner CV joint to the axle shaft flange in two diagonal steps: | |
| - First step | 10 |
| - second phase: | |
| • М8х48 | 40 |
| • М10х52 | 70 |
| Bolts for fastening the body of the inner CV joint type «tripod» to the axle shaft flange in two diagonal steps: | |
| - First step | 10 |
| - second phase: | |
| • М8х18 | 40 |
| • М8х28 | 40 |
| • M10x23 | 70 |
| Wheel bolts | 120 |