Front fender
1. Disassemble the front bumper.
2. Remove the wheel arch insert (wings).
3. Remove the front turn signal lamp and side turn signal repeater.
4. Unscrew the fastening screws 2 of the body front panel module on the relevant side.
5. Unscrew the upper fixing screws 1.
6. After unscrewing the remaining fixing screws 4, 5 and 6, remove the wing 3.
7. Before screwing the fender back on, it is necessary to place one zinc gasket under the screws at the junction points on the section of the front wheel casing and the A-pillar, for example, "AKL 381 035 50".