Manual gearbox 02J car Skoda Octavia 1

Position for assembling the shift actuator
Attention! For vehicles with a radio equipped with an anti-theft jamming code, identify the code and mark it. Attention! In order to perform work in the engine compartment, you need to disconnect the battery cable to...

Disassembly and assembly of Bowden cable drives
Attention! All sliding and contact surfaces must be lubricated with grease "G 052 142 A2". Bowden cable drives 1 - cable gear shifting drive; 2 - cable drive for preselective gearshift control (take off the leash (pos....

Dismantling and assembly of a casing of a drive of a gear change
Gearshift cover 1 – spherical head of the lever of a gear change (when disassembling, you also need to remove the casing, pos. 3); 2 - ring; 3 - casing with a frame (when disassembling, it is also necessary to remove...

Disassembly and assembly of the gear lever
Gear lever 1 - cable drive device for preselective gear shift control (on the crank lever of the preselective gearshift control); 2 - cable shift gear (on the gear lever); 3 - hex head screw, 15 Nm (for mounting bracket...

Disassembly and assembly of the gearbox
Disassembly and assembly of the gearbox I - disassembly and assembly of the cover of the crankcase of the gearbox and 5th gear; II - disassembly and assembly of the gearbox housing and gear shift drive; III -...

Disassembly and assembly of primary and secondary shafts, differential and forks
Input and output shafts, differential and shift forks 1 - differential; 2 - sealing ring (4 pcs, replace every time); 3 - secondary (slave) shaft; 4 – support of an axis of a gear wheel of a backing; 5 – an axis of a...

Assembly and disassembly of the primary (leading) shaft
Attention! If the position of the tapered roller bearings has shifted as a result of replacing parts, the primary adjustment must be re-adjusted (leading) shaft. Primary (leading) shaft 1 - clutch housing; 2 - the outer...

Disassembly and assembly of the secondary (slave) shaft
Attention! When installing new gears or a new secondary (slave) shaft, observe the technical data Both tapered roller bearings must be replaced together. Secondary (slave) shaft 1 – hex nut, 25 Nm + 90° (4 things. for...

Disassembly and assembly of the differential
Attention! Before assembling, heat the tapered roller bearing inner race to 100°C. Replace both tapered roller bearings together. In case of replacement of tapered roller bearings, differential box, gearbox housing and...