Car clutch repair Skoda Octavia 1

Clutch — design description
Mounting reamer of the clutch (the trip rod is led through the gearbox shaft) 1 – a bolt of fastening of a flywheel; 2 - flywheel; 3 - friction disc (plate); 4 - disconnecting the clutch; 5 - clamping ring; 6 -...

Assembly diagram of the pedal mechanism
Assembly diagram of the pedal mechanism 1 - fastening / front wall (for clutch master cylinder and bearing bracket); 2 - seal (replace every time); 3 - bearing bracket; 4 - a screw with a six-sided head; 5 – the pedal...

Clutch spring — disassembly and assembly
Vehicles with left hand drive. Disassembly 1. Remove the lower cover on the driver's side at the bottom left. 2. While compressing the spring with the clutch pedal, press the assembly clip from above "3317". Hole...

Assembly diagram of the hydraulic system 02J
Assembly diagram of the hydraulic system 02J 1 - reservoir for brake fluid; 2 - supplementary hose; 3 – the main cylinder of coupling; 4 - mount (only replace when the clutch master cylinder has been removed); 5 -...

Assembly diagram of the hydraulic system 02K
Assembly diagram of the hydraulic system 02K 1 – a tank for a cooling liquid; 2 – additional hose; 3 – the main cylinder of coupling; 4 - mount (only replace when the clutch master cylinder has been removed); 5 - clutch...

Clutch release mechanism repair 02J
Clutch release mechanism 02J 1 - gearbox; 2 - ball joint, 25 Nm (lubricate with MoS2 based grease "Molyko"; 3 - primary gland (leading) shaft (replace); 4 - guide sleeve with O-ring (the O-ring is put on the guide...

Clutch repair 02J
Attention! Clutch discs and pressure plates with damaged or loose rivet connections must be replaced. Attention! The clutch disc and pressure plate must be selected according to the Parts Catalog, depending on the...

Clutch repair 02K
Attention! Clutch discs and pressure plates with damaged or loose rivet connections must be replaced. Attention! The clutch disc and pressure plate must be selected according to the Parts Catalog, depending on the...

Disassembly and assembly of the waterproof housing
Disassembly and assembly of the waterproof housing 1 - expanding clamp; 2 - cover (in two parts); 3 - waterproof casing seal (put on the flange) Disassembly 1. Unscrew the wiper. 2. Unscrew the top part of the expander...

Disassembly and assembly of side protective pads
Attention! If there are also other protective strips on the body, the new glued strip must be aligned so that it fits well with the existing strips. 1 – a protective overlay of a forward door (self-adhesive); 2 – a...

Removing and installing the roof rail
1 - roof rail; 2 - holding clamp; 3 - Tucker bolts (T-bolts) (welded); 4 - front tip; 5 - rivet; 6 - holding rail; 7 - flashing; 8 - cover (pressed in, covers the connectors for the roof rack); 9 - rear tip Removing...