1. Door
2. Fixed nut
3. Sticky pad
4. External door seal
5. Lid
6. Inner glass groove seal
7. Outer glass groove seal
8. Foam detail
9. Glass guide
Removal and installation of a cover of a door
Remove front door trim. Lift cover -3- at the bottom. Pull cover -3- down and out of door -4-.
Note: If necessary for further work, pull cable -P with sleeve -2- out of cover -3-.
Installation in reverse order.
Removal and installation of the limiter of opening of a door
Remove front door trim. Release screw -2- on A-pillar. Remove screws -3-. Remove the plastic cover above the loudspeaker and remove the door stop -1-. Remove the door travel limiter through the hole formed.
 |  |
Installation
Insert the door travel stop into the hole covered by the cover. Screw in screws -3-, tightening torque 9 Nm. Screw in screw -2-, tightening torque 30 Nm. Install the plastic cover over the speaker. Install the front door trim.
Removal and installation of the lock bracket
Release screws -2- and remove locking clip -1-.
Installation
Place locking clip -1- on B-pillar -3- and tighten screws -2-, tightening torque: 25 Nm. Adjust locking bracket.