Parts and components of the stabilizer

Vehicles with front wheel drive

1. Lower wishbone

2. Nut, 20 Nm and tighten by 180°: replace after each removal

3. Stabilizer bar

4. Bolt, 20 Nm and tightened by 90°: do not skew during installation; replace after each removal

5. Bolt: replace after each removal

6. Nut, 55 Nm: when tightening, hold the inner polygon of the stabilizer pin

7. Stabilizer: with silent block

8. Subframe

Vehicles with all-wheel drive

1. Lower wishbone

2. Nut, 20 Nm and tighten by 180°: replace after each removal

3. Stabilizer bar

4. Bolt, 20 Nm and tighten by 90°: replace after each removal

5. Screw: replace after each removal

6. Nut, 55 Nm: when tightening, hold on to the inner polyhedron of the stabilizer link

7. Stabilizer

8. Subframe