1. O-ring: replace after disassembly
2. Landing pin
3. 8 Nm
4. Sealing gasket: replace after disassembly
5. Bolt
6. Bracket: intake manifold
7. Bolt
8. Bolt: replace after disassembly
9. Landing pin
10.8 Nm
11. Intake manifold with intercooler: the intake manifold with intercooler form a single piece
12. Bolt: replace after disassembly
13. Charge air temperature sender after intercooler -G811-, 22 Nm
14. Sealing gasket: replace after disassembly
15. Connection: Throttle valve unit -J338-
16. Intake air temperature sender -G42-, 22 Nm
17. 10 Nm
18. Coolant pipe
19. 10 Nm
20. Coolant pipe
21. O-rings; replace after disassembly
22. Throttle valve control unit -J338-: with throttle valve potentiometer -G69-
23. O-ring: replace after disassembly
24. Duct
25. Bolt
26. Bracket: Throttle valve unit -J338-
27. Bolt
28. Bolt
Torque and tightening order for intake manifold screws
Tighten the screws in stages.
Intake manifold bracket and throttle body bracket - tightening torque and tightening sequence
Tighten the screws in stages.
Attention! When installing the intake manifold bracket or throttle body, make sure that the brackets are installed free of tension and angular misalignment.
