Removal and installation of lifting cylinders for headlight washer nozzles
Remove the front bumper. Push the injectors out of the bumper (from within) so that you can grab the lid. Slightly pull out the cover, then grab the nozzles and pull them out to the end. Detach cover -1- from support -arrows-.
Using a small screwdriver, press out locks -arrows A- and remove lift cylinder -1- from bumper -arrow B-.
Installation
Installation in reverse order. Insert the lifting cylinder into the supports in the bumper until it clicks audibly. Hoses with elbows must audibly engage in the fittings on the lift cylinders of the injectors. Install bumper. After completing the installation work, bleed the air from the headlight washer system.
Bleeding the headlight washer system
After installation work or during the initial start-up, the headlight washer system must be bled to ensure that it functions properly. Fill the windshield washer and headlight washer reservoir. Start the engine. Use headlights. Operate the headlight washer several times (3-5 pulses of approximately 3 sec.). If necessary, repeat this bleed process until the headlight washer lift cylinders and nozzles function perfectly.