Unscrew nut -3- and disconnect positive cable. Unlock and disconnect connector -2-. If the earth cable is connected, unscrew the nut -1- and remove the earth cable.
Then unscrew upper screws securing starter motor -arrow-. M12 - 80 Nm. M10 -40 Nm.
Vehicles with manual gearbox
Remove soundproofing. Loosen nut -1- (23 Nm) and set aside the wire holder -2- with the wire.
All vehicles
Loosen the lower fixing screws - see. arrow - and remove the starter. M12 - 80 Nm. M10 - 40 Nm.
Installation
Installation in reverse order.
Note: Use new self-locking nuts -1- and -3- to fasten the ground wire and the positive wire.
Tightening torques for positive wire and ground wire
Wire to ground, pos. -1- 20 Nm. Positive wire, pos. -3-: starter with copper screw 16 Nm, starter with steel screw 20 Nm. Observe the procedure for performing work when connecting the battery.