Headlights and vehicle lighting system Skoda Octavia 3

Headlights with halogen lamps — design description
1. Headlight housing 2. Bulb high beam, front running light and position light: 12V, 55W (H15) 3. Lid 4. Servo motor for headlight range adjustment 5. Low beam lamp: 12V, 55W (H7) 6. Lid 7. Screws, 1.5 Nm 8. Lid 9....

Removal and installation of headlights with halogen lamps
Note: Removal and installation are shown using the right headlight as an example. Removal and installation of the right headlight is carried out in the same way. Switch off the ignition and all electrical consumers....

Replacing bulbs in headlights
Attention! Bulbs H7 and H15 are under pressure and may burst when replaced. It is recommended to wear gloves and goggles when replacing lamps. When installing an incandescent lamp, do not touch the glass bulb. Your...

Replacing headlight mounts
If the headlight retainers are broken or damaged, they can be replaced using a repair kit. There is no need to change the whole headlight. Note: Before repair, check whether the headlight has any other damage, as in...

Reconfiguring headlights for right-hand or left-hand traffic
When traveling to countries with right-hand or left-hand traffic, headlights with halogen lamps must be pasted over with a self-adhesive film to prevent dazzling drivers of oncoming vehicles. Note: Headlight adjustment...

Removal and installation of the servomotor correction of the angle of inclination of the headlights
Remove the headlight, from which it is necessary to dismantle the executive electric motor. Remove trim -2-. Left headlight Carefully break off plugs -2-. Unscrew the fastening screws located under the plugs. Note: The...

Bi-xenon headlights — design description
Attention! Dangerous high voltage, risk of injury and environmental pollution. Follow the instructions for use and safety precautions when working with gas discharge lamps. Xenon HID headlamps are bi-xenon headlamps and...

Details and assemblies of the bi-xenon headlight with LED module
Note: The LED module is designed for position light and front running light. The LED module is built into the headlight and cannot be replaced individually. 1. Discharge lamp control unit -J343- left or -J344- right 2....

Replacing incandescent and gas discharge lamps
Note: During installation, do not touch the glass bulbs/discharge lamps. Your fingers may leave greasy marks on the bulb/discharge lamp, which evaporate when the bulb is turned on and cause the bulb to become cloudy....

Removal and installation of lighting control units
Removing and installing discharge lamp control unit -J343- for left or -J344- for right headlight Remove headlight. Remove screws -arrows- (1.4 Nm) and remove control unit -1-. Unlock and disconnect connectors....

Lighting devices in exterior rear-view mirrors
Side direction indicators Switch off the ignition and all electrical consumers. Remove mirror element. Press catches -arrows A- and remove top cover -1- -arrow B-. Remove screws -arrows A-. Press catches -arrow B- and...

Removal and installation of rear lights
Switch off the ignition and all electrical consumers. Insert the tool -T10389- or the hook to remove the decorative cap into the hole in the trim -1- (on-board tool), detach trim -arrow- one by one from retainers -2-...

Rear lights — Octavia
Note: When replacing the parking light bulb (-pos. 4-) do not remove the lamp bracket. To remove, turn the bulb holder to the left and remove it. Release screws -arrow-. Unplug connector -1- and remove lamp bracket....

Rear lights — Combi
To remove, turn counterclockwise and remove the bulb holder. General installation scheme for incandescent lamps 1. P21W stop and side light bulb (12 V, 21 W) 2. Incandescent lamps for side light W5W (12V, 5W). 3. Turn...

Fog lights, fog lights with function «Corner»
General description, fault recognition and indication There are two options for fog lights (except Octavia RS) with the following functions: fog lights; fog lamps with static cornering light function (corner lighting...

Additional brake light
Octavia Switch off the ignition and all electrical consumers. Remove tailgate trim. Remove screws -2- (0.8 Nm). Unlock catches -arrows-. Note: To facilitate the release of the latches, a welding wire with a diameter of...

License plate light
Removal and installation of a lantern of illumination of license plate Switch off the ignition and all electrical consumers. Use a suitable screwdriver -arrow- to pry out the tail light -1- and remove it from the rear...

Interior lamps
Removal and installation of a forward plafond of illumination of salon Carefully! When using a lever tool, seal the places where the lever tool is inserted with ordinary adhesive tape. The shape of the plafonds and...

Removal and installation of the switch of external illumination
Switch off the ignition and all electrical consumers. Turn the rotary knob for the outdoor light switch to position "0". Firmly press the rotary knob for the exterior light switch -arrow 1- and turn slightly to the...

Removing and installing switches in the center console
Switch off the ignition and all electrical consumers. Vehicles with automatic transmission Unclip gearshift cover -2-. Remove switches -1- from below -arrow- from trim -2-. Vehicles with manual gearbox Carefully! When...

Removal and installation of the switch of the emergency light alarm system and a control lamp of deactivation of an airbag
Switch off the ignition and all electrical consumers. Remove the infotainment display module, do not disconnect the wires. Remove switch and warning light -1- from rear central vent -arrow-. Disconnect connector....