Note: During installation, do not touch the glass bulbs/discharge lamps. Your fingers may leave greasy marks on the bulb/discharge lamp, which evaporate when the bulb is turned on and cause the bulb to become cloudy. Observe the correct position of intact seals on the plastic covers and the correct seating of the cover. Water ingress can damage the headlights. The LED module is built into the headlight and cannot be replaced individually. If the module is defective, replace the headlight.
Replacing an incandescent lamp of an additional side light
Headlight with LED module. Switch off the ignition and all electrical consumers. Remove cover -2-.
Grasp the bulb holder -1- and pull it out, paying attention to the length of the connected wires -arrow-.
Remove bulb -2- from socket -1-. After replacing the bulb, insert the bulb socket into the headlight as far as it will go and close the cover.
P21/5W Parking Light and Front Running Light Bulb Replacement
Headlight without LED module. Switch off the ignition and all electrical consumers. Remove cover -2-. Turn bulb holder -1- -arrow- and remove. Replace defective incandescent lamp.
Installation in reverse order.
Replacing the discharge lamp
Attention! Life-threatening high voltage, danger of grass and environmental pollution. Follow the instructions for use and safety precautions when working with gas discharge lamps.
Switch off the ignition and all electrical consumers. Remove cover -1-. To unlock, press tab on connector -2- and pull connector downwards. Turn discharge bulb approx. 45°-arrow- and remove from headlight housing.
Installation
Installation in reverse order. Check headlight adjustment. Perform basic headlight range adjustment.