Messages are displayed until the problem is corrected. After the first display, the characters or continue to be displayed without prompting the driver. For vehicles with a MAXI DOT color display, some control icons are displayed in color.
Attention! Ignoring the control pictograms and messages on the display of the instrument cluster can lead to personal injury and damage to the vehicle. If you are forced to stop due to a technical problem, stop the vehicle at a safe distance from the traffic flow, turn off the engine and turn on the hazard warning lights. The warning triangle must be set at the prescribed distance. The engine compartment of a car is a zone of increased danger.
Rear seat belt warning light
The seat belt in the back seat is not fastened
The seat belt in the back seat is fastened
Control pictograms and light up after the ignition is turned on. When the rear seat belt is fastened or unfastened, the corresponding contr. the icon lights up for a short time and displays the current state of the belt!
Generator
The control lamp lights up when the vehicle's battery is not being charged while the engine is running. Contact a service station immediately.
Carefully! If, in addition to the icon, the icon also lights up (malfunction in the cooling system), stop the vehicle immediately and switch off the engine - otherwise the engine may be damaged!
Coolant
Low coolant level
If the coolant level is too low, the icon lights up and the following message appears in the display of the instrument cluster: «M» Check out the OJ! «S» CHECK COOLANT.
Stop the vehicle, turn off the engine and check the coolant level. If the level is too low, add coolant. If, after topping up the coolant and turning on the ignition, the counter. the icon is off, the movement can be continued. If at a normal level of coolant contr. icon does not go out, check the radiator fan fuse.
Replace blown fuse. If, with a normal coolant level and a whole fuse for the fan counter. the icon does not go out, you can not continue driving! Contact the service station.
Coolant temperature too high
If the coolant temperature is too high, the icon lights up and the following message appears in the display of the instrument cluster: «M» Engine overheated. Stop! «S» ENGINE OVERHEAT. STOP.
Stop and turn off the engine. Wait until the arrow of the coolant temperature gauge returns to the operating range. You can continue moving only after counter. the icon is off.
Attention! Open the coolant expansion tank carefully.
Caution: When the engine is hot, the cooling system is pressurized - risk of burns from liquid splashes or vapours! Therefore, before unscrewing the cover, let the engine cool down. Do not touch the radiator fans. The cooling fan may spontaneously turn on even when the ignition is off.
Engine oil pressure
A flashing icon indicates a low oil level in the engine. The instrument cluster display shows the following message: «M» Dove. oil: stop and mute. move! «S» DAV. OIL STOP STOP ENGINE.
Stop the vehicle, turn off the engine and check the engine oil level. If counter. the icon flashes, it is impossible to continue driving, even with a normal oil level! Under no circumstances should the engine be running, even at idle. Contact the service station.
Engine oil level
Low oil level in the engine
If the and icons are on, this means that the engine oil level is too low. The instrument cluster display shows the following message: «M» Oil level: add oil! «S» ADD OIL
Stop the vehicle, turn off the engine and check the engine oil level. The indicator icon goes out if the hood is left open for more than 30 seconds. If oil has not been topped up, counter. the icon will light up again after about 100 km.
High engine oil level
If the and icons are lit in combination with the following message on the display, the engine oil level is too high: «M» Lower the oil level! «S» OIL LEVEL TOO HIGH.
Stop the vehicle, turn off the engine and check the engine oil level.
Engine oil level sensor
If the and icons are lit in combination with the following message on the display, this means that the engine oil level sensor is faulty: «M» Oil sensor: for repair! «S» OIL SENSOR IN REPAIR.
Contact a service station immediately.
Attention! If in this situation you do not have the opportunity to add oil, you cannot continue driving! Shut off the engine and contact a service station.
Lamp failure
The control pictogram lights up when the lamp is burned out. The instrument cluster display shows, for example, the following message: «M» Check the dipped beam on the right!, «IN» CHECK LOW LIGHT RIGHT.
Particulate filter (diesel engine)
The particulate filter cleans the exhaust gases from soot. Soot accumulates in the particulate filter and is periodically burned. If the counter is lit. icon, it means that the filter is filled with soot. To clean the particulate filter, when traffic conditions permit, drive in the mode described below for at least 15 minutes or until the icon goes out: 4th or 5th gear (with automatic transmission: position D/S); the speed of movement is not lower than 70 km/h; engine speed in the range of 1800-2500 rpm.
After successful cleaning of the filter the icon goes out. If the attempt to clean the filter was unsuccessful, the icon remains lit and the counter starts flashing. lamp. The instrument cluster display shows the following message:
«M» Sazhev. filter! «IN» PARTICULATE FILTER BOARD DOCUMENT.
Contact a service station immediately.
Attention! The particulate filter is heated to a high temperature. Therefore, do not park the vehicle in places where the heated filter may come into contact with dry grass or other flammable materials. Called counter. The need to drive at a certain speed for a certain time can in no way be considered as an excuse for violating the established speed limit.
Carefully! While the counter is lit. pictogram, you will have to put up with increased fuel consumption and, in some cases, with a decrease in engine power. When the vehicle is operated on diesel fuel with a high sulfur content, the service life of the particulate filter can be significantly reduced. A / m is not recommended to use all the time only for trips over short distances. Long trips contribute to the burning of accumulated soot in the particulate filter. If the engine is turned off during filter cleaning or shortly thereafter, the radiator fan may turn on spontaneously for several minutes.
Fluid level in windshield washer reservoir
The control pictogram lights up when the fluid level in the washer reservoir is low. The instrument cluster display shows the following message: «M» Add washer fluid! «S» ADD WASHER LIQUID.
Add liquid.
Fuel reserve
When the counter lights up. pictogram, there are still approximately 7 liters of fuel in the fuel tank. The instrument cluster display shows the following message: «M» Refuel a / m. Power reserve:... km. «3» GET FUEL.
In addition, a warning sound signal is also heard.
Note: The message will disappear after the vehicle has been filled with fuel and driven a short distance.
High beam assistant
The control pictogram lights up when the high beam assistant is on.
START-STOP system
Control pictograms show the status of the START-STOP system.
Ice Warning
The control pictogram draws attention to the danger of sleet.
Water in the fuel filter (diesel engine)
The fuel filter with water separator filters water and contaminants from the fuel. If too much water accumulates in the water separator, the following message appears on the display in the instrument cluster.
MAXI DOT display
The control icon lights up.
«M». Water in the fuel filter.
Segment display
«S» WATER IN FUEL FILTER
Carefully! Contact a service station immediately.