Note: If the light switch fails, the dipped beam will automatically turn on. The headlights may fog up from the inside for a while. When the headlight is turned on, the light passage area is quickly cleared of fogging, but sometimes fogging persists for a while at the edges of the lens. This fogging does not affect the life of the lighting fixtures. When the side lights, dipped beam or main beam are turned on, the illumination of the instrument cluster is also turned on. The brightness of the instrument cluster illumination is set in the Infotainment system.
Side lights and dipped beam
Light switch and headlight range control
Light switch positions A
0: Light off (except for daytime lighting)
AUTO: Automatic lighting on/off
Turn on side lights, or parking lights on both sides of the vehicle
Turn on low beam
Fog lights on
Turn on the rear fog light
Headlights corrector
By turning the knob B from position - to position 3, the headlight range control gradually adapts, reducing the length of the headlight beams. The positions of the headlight range control roughly correspond to the following loading options:
The front seats of the vehicle are occupied, the luggage compartment is empty
1. All car seats are occupied, the luggage compartment is empty
2. All car seats are occupied, the luggage compartment is loaded
3. The driver's seat is occupied, the luggage compartment is loaded
Attention! The headlight range must always be adjusted so that the following requirements are met. The headlights of the car do not dazzle the drivers of other vehicles, especially in the opposite direction. The lighting range is sufficient for safe driving. It is recommended to adjust the position of the headlights with the dipped beam on. After switching on the ignition and while driving, the bi-xenon headlights automatically adjust to the degree of load and the driving mode of the vehicle. Vehicles with bi-xenon headlights are not equipped with a manual headlight range control. The dipped beam is on when the ignition is on and the light mode switch is in the or AUTO position. After switching off the ignition, the dipped beam automatically turns off, and only the side lights remain on. The side lights turn off when the key is removed from the ignition switch.
Daylight mode (DAY LIGHT)
Day mode provides illumination of the area in front of the vehicle.
Switching on daylight mode
Turn light switch A to position 0 or AUTO.
Switching on/off daytime running lights on vehicles with infotainment
Daylight mode can be activated or deactivated in the Infotainment system.
Switching off daytime running lights on vehicles without infotainment
Pull the turn signal/high beam stalk towards the steering wheel and move it down. Simultaneously turn on the ignition, and hold the switch in this position for at least three seconds.
Activating daytime running lights on vehicles without infotainment
Pull the turn signal/high beam stalk towards the steering wheel and lift it up. At the same time, turn on the ignition, and hold the switch in this position for at least 3 seconds. Daytime running light switches on automatically under the following conditions: the ignition is on; daylight function activated; the light switch is in position 0 or AUTO.
Note: When the daytime running lights are on, the parking lights (neither front nor rear) and license plate lights are off.
Direction indicators and high beam
Steering column switch for direction indicators and high beam
Steering column positions
A. Turn on «right arrow» right direction indicators
B. Turn on «left arrow» left direction indicators
C. Turn on high beam (non-latching position)
D. High Beam Off/Beam On (non-latching position)
With the help of the steering column switch, the parking lights are also controlled. You can turn on the high beam only when the low beam is on. When the main beam is on or a light signal is on, the counter lights up in the instrument cluster. lamp.
When the left or right direction indicator is on, the control flashes in the instrument cluster. lamp
or 
.
If, on vehicles with high beam assist, the selector lever is moved to position C, the assistant is switched on.
«Comfortable turning on of the direction indicators»
To flash the direction indicators three times, briefly press the lever up or down to the point of resistance and release. «Comfortable turning on of the direction indicators» can be activated or deactivated in the infotainment system. Lane Change Warning - For a short turn signal, move the lever up or down to the point of resistance and hold it in that position.
Note. You can turn on the light signal even when the ignition is off. The turn signals turn off automatically after the turn is completed. If one of the turn indicator lamps on the vehicle burns out, check. the lamp starts flashing at a double frequency.
Automatic dipped beam
Light switch
When the light switch is set to the AUTO position, the side lights, dipped beam, and license plate light turn on and off automatically. Lighting is regulated based on data recorded by a sensor located between the windshield and the interior rear-view mirror. The sensitivity of the light sensor can be set in the Infotainment system. When the light switch is set to the AUTO position, the AUTO symbol next to the switch lights up. When the light turns on automatically, the
symbol next to the light switch also lights up.
Switching on driving lights when it rains
If the switch is set to the AUTO position, and the automatic wiper operation in the rain, or the wiper operation (in position 2 or 3) lasts more than 30 seconds, the side lights and dipped beam will automatically turn on. The light turns off when the auto-wiper function or the wipers (in position 2 or 3) do not work for about four minutes. The automatic light switch-on in the event of rain can be activated or deactivated in the Infotainment system.
Adaptive headlights (AFS)
The AFS adaptive lighting system works in conjunction with the AUTO lighting control function, so you should also read the following information. The AFS system provides the driver with road lighting depending on traffic and weather conditions. The system adapts the shape of the light cone of the headlights in front of the vehicle depending on the speed of the vehicle, the operation of the windshield wipers, the fog lights and the information from the Infotainment navigation system. The AFS system only works when the following condition is met: the light switch is in the AUTO position. The AFS system operates in the following modes.
Country mode
The shape of the light cone of the headlights in front of the vehicle is close to the shape of the dipped beam cone. This mode is activated if the following modes are not activated.
City mode
The light cone in front of the vehicle has been adapted so that it captures adjacent sidewalks, intersections, pedestrian crossings, etc. This mode is active at a speed of 15-50 km/h.
Motorway mode
The light cone of the headlights in front of the vehicle is adapted in such a way that the driver can react in a timely manner to an obstacle or other danger. The mode is active at speeds above 110 km/h.
Rain mode
The light cone of the headlights in front of the vehicle is adapted in such a way that the degree of blinding of drivers of oncoming vehicles is reduced when it rains. This mode is activated at a speed of 50-90 km / h, if the wipers have been running continuously for more than 2 minutes. The mode is deactivated when the wipers are not operated for more than eight minutes.
Fog mode
The light cone of the headlights in front of the vehicle is adapted so that the driver is not dazzled by the headlights reflecting off the fog. This mode is activated at a speed of 15-70 km / h and if the rear fog lamp is on for more than 10 seconds. The mode is turned off when the rear fog light is turned off for more than 5 seconds.
Dynamic adaptive lighting
The light cone of the headlights in front of the vehicle is adapted in such a way that the carriageway in the cornering area is illuminated. This function is active at speeds above 10 km/h and in all modes of the AFS system.
Attention! In the event of a malfunction of the AFS adaptive lighting system, the headlights are automatically set to an emergency position to prevent dazzling oncoming drivers. As a result, the range of the light cone of the headlights in front of the vehicle is reduced! Therefore, drive carefully and contact a workshop immediately. When you select the Eco driving mode, the AFS system is deactivated.
High beam assistant
Control lever
The high beam assistant automatically switches the high beam on and off depending on the ambient conditions. The high beam is adjusted based on data recorded by a camera located between the windshield and the interior rearview mirror. The high beam assist function can be switched on and off in the Infotainment system. The high beam can turn on automatically at speeds above 60 km/h. It automatically turns off when the speed drops below 30 km/h. When the assistant automatically turns on the high beam, the counter lights up in the instrument cluster. lamp.
Activation
Turn the light switch to the AUTO position. Move the lever to position A (spring loaded position). Contr. appears on the display of the instrument cluster. pictogram of the active high beam assistant.
Deactivation
If the high beam is already on automatically, move the stalk lever to position B (spring loaded position). If the high beam is not already on automatically, set the stalk lever to position A (high beam will turn on), and then to position B. If you want to turn on the assistant again, move the stalk lever to position A. The assistant can also be turned off by turning the light switch from the AUTO position to any other position.
Switching on high beam manually
If the main beam is not turned on automatically, it can be turned on manually - set the stalk lever to position A. The assistant turns off, counter. the icon goes out.
Switching off high beam manually
If the main beam is turned on automatically, it can be turned off manually - set the stalk lever to position B. The assistant turns off, counter. the icon goes out.
Warning message
Messages and instructions are shown in the instrument cluster display: «M» Failure in the operation of the assistant control. distant light. «S» DISTURBANCE OF WORK ASSIS-TA DAL. SVETA.
Contact the service station. «M» Asya. ex. far light: clear the winds. glass! «5» CLEAN WINDSHIELD.
Check that there are no obstructions in the camera field of view on the windshield.
Fog lights
Light switch
Turn on/off
Turn the light switch to AUTO
or 
.
Set the light switch
to position 1. The fog lights turn off in reverse order. When the fog lamps are on, the counter lights up in the instrument cluster. lamp
Fog lights with CORNER function
The CORNER function uses the fog lights to better illuminate the area on the corresponding side of the vehicle when turning, parking, etc. The CORNER function is activated automatically when the following conditions are met: the turn indicators are on or the front wheels are turned strongly to the right or left (1); the engine is running; the vehicle stands still or moves at a speed of no more than 40 km/h; the low beam is on or the light switch is set to AUTO and the low beam is on; daylight mode off; fog lights off.
(1) In the event of a conflict in management (e.g. the front wheels steer to the left when the right turn signals are on), priority is given to direction indicators.
The CORNER function is intended primarily for lighting the near space in a wide sector in front of the car and next to the car. Switching on and off is gradual.
Note: When reverse gear is engaged, both fog lamps are switched on.
Rear fog lamp
Turn on/off
Turn the light switch to AUTO, or
or 
.
Set the light switch to position 2. The rear fog lamp turns off in reverse order. If the vehicle is not equipped with fog lamps, the rear fog lamp is switched on by pulling the light switch directly to position 2. This switch can only be pulled out to one position. When the rear fog lamp is on, the counter lights up in the instrument cluster. lamp
.
If the vehicle is equipped with a factory-fitted towing hitch or retrofitted with a towing hitch from the ŠKODA range, only the trailer's rear fog light comes on when driving with a trailer.
COMING HOME/LEA VING
COMING HOME/LEAVING HOME function (hereinafter briefly: function) provides automatic switching on of lighting for a short time in conditions of poor visibility, after leaving the vehicle and when approaching it. The function is activated automatically when the following conditions are present: the light switch is in the AUTO position; visibility around the vehicle is poor; ignition is on. This function and the lighting duration setting can be activated or deactivated in the Infotainment system. Lighting is regulated based on data recorded by a sensor located between the windshield and the interior rear-view mirror. Side lights and dipped beam, sill lights in the exterior mirrors and license plate lights are switched on.
COMING HOME
The lighting switches on automatically when the driver's door is opened. The lighting goes out when all doors and trunk are closed after the set delay time has elapsed. If one of the doors or the boot lid is left open, the lights will go out after 60 seconds.
LEAVING HOME
The lighting switches on automatically when the vehicle is unlocked using the remote control. The lighting switches off after the set delay time has elapsed or after the vehicle has been locked.
Note: Frequent activation of the function, especially when short trips predominate, leads to battery depletion.
Emergency light signaling
Hazard light button
Turn on/off
Press the
key.
When the hazard warning lights are turned on, all direction indicators start flashing. Also starts blinking. turn signal lamp and counter. key lamp. The emergency light alarm system can be included and at the switched off ignition. When the airbag is deployed, the hazard warning lights turn on automatically. If you turn on the direction indicator with the alarm on and the ignition on, it will only work on the corresponding side of the vehicle.
Parking lights
Turning on the parking lights
Switch off the ignition. Move the steering column switch
to position A or B until it stops - the parking lights on the right or left side of the car will turn on.
Switching on the parking lights on both sides of the vehicle
Turn light switch A to position and lock the vehicle.
Note: The parking lights only work when the ignition is off. If you turn off the ignition while the right or left turn signal is on, the parking lights will not turn on automatically.