SkodaBook.ru

Fabia Rapid Octavia Superb Kodiaq Yeti Others

Octavia 1 (1996-2004) Octavia 3 (2013-2019)

Removing and installing oil nozzle control valve for piston cooling -N522-

0

Disconnect connector -arrow- from control valve for oil nozzles for piston cooling -N522-. Remove screw -1- and remove piston cooling oil jet control valve -N522- -2-.

Installation

Installation in reverse order.

Note: Replace sealing rings. To avoid loss of engine oil, immediately push a new piston cooling oil jet control valve -N522- into the hole.

Check engine oil level.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Skoda Octavia 3: Engine repair

Parts and assemblies of the oil pressure sensor
Removal and installation of an oil separator
Details and components of the crankcase ventilation system
Removal and installation of the mechanical distribution valve
Removing and installing engine oil cooler
Attachment bracket with oil filter and engine oil cooler
Removal and installation of the upper part of the oil pan
Removal and installation of the oil pump
Removal and installation of the lower part of the oil pan
Removing and installing oil level and oil temperature sender -G266-

Removal and installation of oil sensors
Removing and installing oil pressure control valve -N428-

Read similar articles on other Skoda models

➧ Removing and installing the antenna Skoda Fabia 1 (1999-2007)
➧ Valve timing control over time (1.4 TSI engine) Skoda Rapid 1 (2012-2022)
➧ Removing and installing auxiliary bracket and accessory drive belt Skoda Superb 2 (2008-2015)
➧ Brake pressure control valve (pickup models) — health check Skoda Favorite (1987-1994)

Link to this article in various formats

TEXTHTMLBB Code

Reviews and comments of visitors

No comments yet

Octavia 3 (2013-2019)