Removing
1. Remove the rear door window handle.
2. Remove rear door trim panel (for details, see the relevant section in this chapter).
3. Fix the rear door glass with adhesive tape.
4. Unscrew the fastening screws (2), shown in the figure below.
5. Remove mechanical drive (1) from the supports of the drive drum of the power window mechanism (3), as shown in the figure below.
Installation
1. Install the mechanical drive on the mechanical window drum supports. Raise the window and carefully lower it so that the drive shaft is securely engaged with the window lifter drum.
2. Install and tighten the power window mechanical drive screws with a tightening torque of 3 Nm.
3. Further installation is carried out in the reverse order of removal.
