Removing
1. Remove the right drive shaft from the gearbox and hang it with a piece of wire.
2. Unscrew the fastening bolts, shown in the figure below by arrows, on both sides.
3. Remove the mounting clamp from the stabilizer bushing.
4. Remove the rubber bushing from the anti-roll bar.
Installation
1. Install a new rubber bushing on the anti-roll bar (1), as shown in the figure below.
Note.
- Make sure that the rubber bushing rests against the stopper (2).
- Depending on the modification of the car, the stopper (2) can be located both internally and externally.
2. Install the mounting bolts shown in the figure below on both sides and tighten them to the required torque.
3. Install the right drive shaft into the gearbox.
Tightening torques for threaded connections
