Car rear suspension Skoda Rapid 1

Setting the rear suspension to the curb weight position
Note. Necessary special devices, control and measuring devices, as well as auxiliary means: Mounting clamp -T10038-. Holder -T10I49-. Device for removing and installing engine and gearbox e.g. -VAG 1383/A-. All screws...

The appearance of the rear suspension
1. Rear wheel bolt, tightening torque 120 Nm 2. Fastening screw, tightening torque 4 Nm 3. Brake drum 4. Lid 5. Self-locking hex nut, tightening torque 70 Nm + 30° 6. Rear wheel hub with bearing 7. Rear wheel hub with...

Rear suspension beam assembly — removal and installation
Note. When removing the rear suspension beam assembly, the right side silent block mounting bracket must be removed with the beam. After replacing the silent blocks of the rear beam, it is necessary to check the...

Shock absorber — removal and installation
Note. To remove the shock absorber, it is not necessary to remove the coil spring. Removing 1. Remove the wheel, raise the car, then remove the fender liner (for details, see the relevant section in chapter Body ). 2....

Rear suspension spring — removal and installation
Removing Note. To remove the left spring, it is necessary, due to lack of space for a coil spring compression tool (V.A.G 1752/1), partially remove the rear muffler. 1. Raise the car. 2. Partially remove (unhook) rear...

Hub and bearing — removal and installation
Removing 1. Remove the rear wheel. 2. Release the brakes (set the brakes to their original position). 3. Move the wedge (self-adjusting state of the parking brake lever) through the hole for the wheel bolt in the brake...

Rear wheel trunnion — removal and installation
Attention. Proper work on the axle trunnion is prohibited. Stripping the thread of the trunnion of the axis with a tap is prohibited. 1. Remove wheel hub with wheel bearing (see above). 2. Remove the brake line from the...