Attention. H7 and H15 bulbs are pressurized and may break when replaced, resulting in personal injury. Wear protective gloves and goggles before starting lamp replacement work.
Attention.
- When replacing an incandescent lamp, do not touch its bulb with bare fingers, but use clean gloves. Oil from fingers may remain on the surface of the lamp bulb and, as a result, the lamp may collapse or the oil may darken and condense on the surface of the reflector, which will affect the luminosity of the headlights.
- When installing rubber covers, be extremely careful to install them properly. Otherwise, moisture and water may get inside the headlight housing.
- Before starting any work, turn off the ignition and all electrical energy consumers.
Replacing the discharge lamp
1. Remove headlight assembly (more, see relevant section in this chapter).
2. Unscrew the fastening screws (1) and remove the cover (2), shown in the figure below.
3. Disconnect the wiring harness connector.
4. Turn the locking tabs (1) in the direction of arrows A as shown in the figure below.
5. Gently pull the lamp (2) in the direction of arrow B as shown in the figure below. Remove the discharge bulb from the headlamp housing.
6. Installation is made in reverse order to removal.
7. After installation, it is necessary to adjust the headlights.
Replacing the high beam headlight bulb and daytime running light system
1. Remove the battery for better access to the left headlight (for details, see the relevant section in chapter Engine electrical equipment).
2. Remove the rubber cover (2), shown in the figure below.
3. Turn the incandescent lamp (1) to the left (arrow) and remove it from the headlamp housing as shown in the figure below.
4. Installation is made in reverse order to removal.
Replacing the parking light lamp headlights
1. Remove the rubber cover (1), shown in the figure below.
2. Swinging from side to side, remove the lamp holder (1), by pulling it in the direction of the arrow, as shown in the figure below.
3. Remove the incandescent lamp from the cartridge.
4. After replacing the incandescent lamp, install and press the cartridge into the headlamp housing.
5. Install the rubber cover.
Replacing the turn signal lamp
1. Rotate the chuck (4) to the left and remove from the headlamp housing as shown in the figure below.
2. Replace the damaged incandescent lamp.
3. Installation is made in reverse order to removal.
