Note.
- Necessary special devices, control and measuring devices, as well as auxiliary means.
- Container for collecting coolant.
Removing
Note.
- The integral seal of the liquid cooling pump must not be separated from the liquid cooling pump.
- If the liquid cooling pump is damaged or leaking, it must be replaced along with the seal.
1. Drain the coolant from the engine cooling system.
2. Remove the water pump pulley (for details, see the relevant section in this chapter).
3. Disconnect the vacuum line from the liquid cooling pump (1), shown in the figure below, of the coolant circulation solenoid valve -N492-.
4. Unscrew the fastening screws (arrows), remove the coolant pump.
Installation
Installation is carried out in the reverse order of removal.
Tightening torque: 9 Nm.
Install the water pump pulley (for details, see the relevant section in this chapter).
Fill the cooling system with fresh coolant and remove air from it (for details, see the relevant section in this chapter).