Note.
- Necessary special devices, control and measuring devices, as well as auxiliary means:
- Socket wrench -T10370-.
Removing
1. Disconnect the wiring harness connector (arrow) from the engine speed sender -G28- as shown in the figure below.
2. Loosen retaining screw for engine speed sender -G28- using socket wrench -T10370-.
3. Remove engine speed sender -G28- from cylinder block.
Installation
1. Install engine speed sender -G28- and tighten retaining screw to 5 Nm.
2. Next, the installation is carried out in the reverse order of removal.