1. High pressure fuel pump bolts, tightening torque When installing 20 Nm
2. High pressure fuel pump
3. Lid
4. To the air filter
5. Camshaft position sensor mounting bolt, tightening torque when installing 10 Nm
6. Camshaft position sensor
7. Bolt for securing the camshaft housing, tightening torque when installing 10 Nm + tighten by an angle of 90°
8. Carter (frame) camshafts
9. Bolts for fastening the mounting eye, tightening torque when installing 20 Nm
10. Mounting eye
11. Turbocharger assembly
12. Engine oil pressure sensor
13. Cylinder head gasket
14. Cylinder head assembly
15. Guide bolt, installation torque 20 Nm
16. Screw plug
17. Locating pin
18. Mesh oil filter
19. Hydraulic valve compensator
20. Roller rocker
21. Cylinder head bolt assembly, tightening torque when installing 30 Nm + tighten by 270°
22. O-ring
23. Roller pusher
24. O-ring
Note
- In the case of reinstallation of the cylinder head, it is necessary to lubricate with oil all contact areas between the supporting elements, rocker arms and friction surfaces of the cams before installing the camshaft housing.
- The plastic washers supplied to protect the opened valves can only be removed before the cylinder head is installed.
- When replacing the cylinder head, it is also necessary to change the entire filling volume of the coolant.
- Before starting assembly work, all bearing surfaces and running surfaces must be lubricated with oil.