Removal and installation of the hatch of a jellied mouth of a fuel tank, with a cover

1. Remove the bolt (3 on resist. illustrations) and gently pull out the sunroof assembly slightly (2) from the rear fender without damaging the paintwork.



2. Pull the rubber part of the assembly through the tank neck and pull the drain hose out of the assembly (4 in illustration 8.1).

3. If you need to remove the safety block (1 in illustration 8.1), switch off the ignition, disconnect the connector in the luggage compartment and pull the wiring through the hole in the wheel arch.

4. Installation is carried out in the reverse order. Tighten the bolt to 1.5 Nm.