2. Remove the air cleaner (see chapter 4).
3. Remove the protective cover (see resist. illustration).
13.3 Removing the protective cover
4. Give the nut (3 on resist. illustrations) and disconnect the positive wire from the starter. Disconnect connector (2), give the nut (1) and loosen the ground wire.
13.4 Starter connections
5. Turn out the top bolt of fastening of a starter (see resist. illustration).
13.5 Upper starter mounting bolt
6. On models with a manual transmission, remove the soundproofing, give the nut (1 per resist. illustrations) and set aside the holder (2) along with wiring.
13.6 Nut (1) cable holder, 23 Nm
7. Remove the bottom bolt (see resist. illustration) and remove the starter.
13.7 Lower starter mounting bolt
8. Installation is carried out in the reverse order. Use new nuts (1 and 3 in illustration 13.4).