Removing
Air cleaner
1. Remove the air cleaner element.
2. In the engine compartment, squeeze the legs of the large spring clamp with pliers and disconnect the air supply hose from the intake manifold cover.
3. The air cleaner housing is located on the right front wheel arch mudguard and secured with a plastic nut. At the same time, two rubber casing supports are threaded into holes in the mudguard. Give a nut, release rubber support and take an air cleaner casing from an impellent compartment.
Inlet pipe with cover
4. Turn out five bolts of fastening of a cover of the inlet pipeline.
5. Remove the ventilation pipe from the camshaft cover, or loosen the clamp and disconnect the pipe from the intake manifold cover.
6. If you have not done this before, release the clamp and disconnect the intake duct.
7. Raise the intake manifold cover by swinging it back over the engine compartment. The cover is put on the air inlet pipes and cannot be removed from them until the pipeline is removed. Check the condition of the rubber seal, replace if necessary.
8. Turn out bolts of fastening of inlet air branch pipes - bolts are used also for fastening of the pipeline - and remove assembly of the pipeline with branch pipes and a cover from a back part of a head of cylinders. Remove the pipeline mounting gasket.
Installation
Installation is in the reverse order. If the intake manifold has been removed, be sure to replace the gasket. Check the condition and patency of the ventilation pipe. Clean it if necessary or replace it.